How to Apply

Your Seamless One Piece Wallpaper.

Jack Harry and Ollie Installation tip

The smoother and cleaner the wall the better finish your peel and stick wallpaper will be.

Product Quality Check
How our Seamless One Piece Wallpaper is prepared for you

We print and cut your wallpaper here at our production studio in Perth Western Australia.

Before we send out your wallpaper we ensure that the print is supplied to the total size requested with 50mm (2") printed extra all around just in case your wall isn't true and square. We've found that not every wall is the same so we take a belts and braces approach to supply of our product (just in case).

Step 1
What Tools will I need?

There's not many tools required for the installation. You can purchase a supplied set of the tools shown from us but you may have these to hand or can purchase these from your local hardware store.

STRAIGHT EDGE | SHARP CRAFT KNIFE | FINE FILLER, APPLICATOR AND SANDING BLOCK/SHEET) FOR ANY SMALL HOLES IN YOUR WALL) | VINYL APPLICATOR SQUEEGEE

Step 2
PREPARE YOUR WALL

The smoother and cleaner the wall the better finish your seamless wallpaper will be.

Fill in and sand back level any small holes or cracks you can find and give your wall a clean over with a dry cloth to remove and dust or grit prior to application.

Step 3
Paste the wall edges

Paste the outside edges of your wall and come inside by round 200mm(8"). Also do the same around any sockets or TV ariel points to allow the next stage roller application.

Step 4
Paste the remaining wall area

Pour some wallpaper paste into a paint roller tray and load up your roller. Begin to roll onto the wall and make sure you overlap onto the previous paste applied.

step 5
Apply your wallpaper

With a second person hold the wallpaper like a curtain and present it to the wall. Best practice is the line up the top of the print with the top of the wall and let the print drop to the floor. This will mean you can avoid having another edge to trim. Ensure that your have print overlapping the left, right and bottom of wall.

Step 7
Fix the wallpaper to the wall

Starting from the top middle of the wall begin to fix the print to the wall by squeegeeing from the middle to the left and right areas and top to bottom.

JACK HARRY AND OLLIE INSTALLATION TIP

Once you've applied the wallpaper and trimmed it down, leave it around 15 minutes to settle. Take a look over the wall and if you see any small air bubbles then squeegee it out to the nearest edge.

step 6
trim your wallpaper

Once you've applied your wallpaper it's time to trim the extra wallpaper off. Place the straight edge against the corner you want to trim (top or bottom) and pull the straight edge across the wallpaper whilst applying pressure with the knife against the wallpaper. You will get a better cut if you do not pull the knife against the wallpaper.

JACK HARRY AND OLLIE INSTALLATION TIP

Once you've applied your wallpaper then with a wet sponge wash down the face of the wallpaper to remove any remaining paste that may be there.

Congratulations

You've just installed your seamless one piece wallpaper.